Dremel 3000 Operating/s Bedienungsanleitung PDF herunterladen (Seite 16)

GET STARTED / FIRST PRINT

In Panel menu choose:

OK >> PLAY >> SD >> TEST

and select one of test les (for example testriangle.g) and press OK

Important: It is essential to pay attention how the rst print layer sticks

to the bed. If the nozzle is positioned too high, the print won’t have any good contact

and heat up well. This will result in curling the edges and deformations during higher

layers. If nozzle height is not even for entire table area, check the calibration.

If the nozzle is too low (touches the glass during rst layer)

- lament will jam due to nozzle blockage. If this happens:

Re-position the Z-endstop, and home Z axis

(check the clearance with sheet of paper).

Retract the lament entirely out of the extruder.

Cut 10-20mm o, and load it back again.

Aer printing the triangle you can see how well it sticks to the table

- this will give good information about table atness and calibration.

If the print does not stick well:

Make sure that table is fully covered with ABS juice or glue

Make sure it’s hot

Slow down the print

You can do it by pressing DOWN button during printing

(100% means normal speed, anything less is proportionally slower)

GCODES

VOXELIZER SOFTWARE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Keine Kommentare

Dremel 3000 Operating/s Bedienungsanleitung Seite 16